Live Network Ports in Public Areas
Network ports in public or visitor areas give any connected device access to the internal network without authentication.
| Severity | Medium |
| CVSS 3.1 | 5.4 CVSS:3.1/AV:A/AC:L/PR:N/UI:N/S:U/C:L/I:L/A:N Open in the calculator |
| CVSS 4.0 | 5.3 CVSS:4.0/AV:A/AC:L/AT:N/PR:N/UI:N/VC:L/VI:L/VA:N/SC:N/SI:N/SA:N Open in the calculator |
| CWE | CWE-306: Missing Authentication for Critical Function |
| OWASP Top 10 | A07:2025 Authentication Failures |
| MITRE ATT&CK | T1200 Hardware Additions |
| Category | Security Misconfiguration |
Description
Live network ports were found in areas that visitors or the public can reach, such as reception, meeting rooms, training rooms, corridors and shared kitchens, and a device connected to them was given an address on the internal network without any authentication. Ports used by devices in those areas, such as IP phones, printers, screens and video conferencing equipment, give the same access when the device is unplugged and a laptop connected in its place.
Where network access control is in place, it is often based only on MAC addresses, which can be copied from a label or from the device being replaced, or it covers only some ports. An attacker who can spend a few minutes in a public or visitor area can therefore gain a position on the internal network without credentials, the starting point for most internal attacks, and carry out any attack available to an internal device, such as capturing credentials through name resolution poisoning and attacking internal services. Leaving a small concealed device with its own mobile data connection turns this into persistent remote access to the internal network. The impact depends on what the connected network can reach and on the internal network's own defences.
The finding is identified by connecting a test laptop to ports in accessible areas, and in place of accessible devices, and recording whether it receives an internal address and can reach internal systems.
Remediation
Make sure that ports in accessible areas give unknown devices no internal access:
- Disable switch ports that are not in use, and re-enable them only through a change request.
- Deploy 802.1X port-based network access control, preferably with certificate-based EAP-TLS for corporate devices, and place unauthenticated devices in a restricted VLAN with no internal access.
- For devices that cannot use 802.1X, such as some printers and phones, use MAC authentication bypass only with device profiling and a VLAN that allows just the traffic those devices need, and alert when a known MAC address appears on an unexpected port.
- Where visitors need wired connectivity in meeting rooms, connect those ports to the guest network rather than the corporate one.
- Use switch port security features to limit the number of devices per port, and alert on link changes on ports in public areas.
- Where practical, move network points out of public areas or fit lockable covers.
Confirm the fix by repeating the connection test on each accessible port.
References
Add This Finding to Your Library
In Pental this write-up is in Settings, Library. Add to my library copies it into your own, rated in your firm's CVSS version, ready to put in your own words.
Free trialYour trial starts when your portal goes live, not when you sign up, so the time you spend setting up does not count. · No card required
Only need the reporting? Our reporting tool is free and open source, with the same library.