Rogue Access Point Detected
An unauthorised access point is connected to the internal network, providing a wireless route into it that bypasses the organisation's wireless and physical controls.
| Severity | Medium |
| CVSS 3.1 | 5.4 CVSS:3.1/AV:A/AC:L/PR:N/UI:N/S:U/C:L/I:L/A:N Open in the calculator |
| CVSS 4.0 | 5.3 CVSS:4.0/AV:A/AC:L/AT:N/PR:N/UI:N/VC:L/VI:L/VA:N/SC:N/SI:N/SA:N Open in the calculator |
| CWE | CWE-288: Authentication Bypass Using an Alternate Path or Channel |
| OWASP Top 10 | A07:2025 Authentication Failures |
| MITRE ATT&CK | T1200 Hardware Additions, T1669 Wi-Fi Networks |
| Category | Security Misconfiguration |
Description
A wireless access point that is not part of the organisation's managed infrastructure was found connected to the internal network. Typical examples are a consumer router plugged into a desk or meeting room network port, a printer or other device broadcasting its own wireless network while connected to the wired network, a laptop sharing its wired connection as a hotspot, or a device deliberately placed by an intruder. Such devices are usually installed with default or weak settings: open, protected by a default or simple key, or with Wi-Fi Protected Setup enabled.
A rogue access point bridges the wired network to anyone in radio range, possibly outside the building. An attacker can connect to it and gain a position on the internal network without passing any authentication, the same starting point as plugging into an internal network port, and from there discover and attack internal systems and intercept traffic. It sits outside the controls applied to the managed wireless network, such as 802.1X authentication, client isolation and monitoring, and its presence shows that the port it uses accepts unknown devices. The rating assumes the access point is open or weakly protected, as is typical; a well-secured unauthorised access point is less exposed but still escapes central management and monitoring.
Rogue access points are identified by surveying the wireless networks visible from the premises and correlating them with the wired network, for example by matching wireless and wired MAC addresses, by tracing the switch port the device is connected to, or by connecting to the unknown network and checking whether internal addresses are reachable. Wireless intrusion detection on enterprise controllers performs the same correlation automatically. Neighbouring organisations' networks are not rogue access points unless they connect to the organisation's network.
Remediation
Remove the device and address the conditions that allowed it:
- Locate the access point through the switch's port and MAC address tables, disconnect it, and establish who installed it and why. Where it was meeting a genuine business need, provide that through the managed wireless network.
- Enforce network access control on wired ports, such as 802.1X port authentication, so that unknown devices are not given internal network access, and disable unused switch ports.
- Enable rogue access point detection in the wireless controller or a dedicated wireless intrusion prevention system, with alerts for unknown access points seen on the wired network and for access points broadcasting the organisation's network names. Use automatic containment with care, because transmitting deauthentication frames at networks that do not belong to the organisation can be unlawful in some jurisdictions.
- State in policy that only the IT function may connect network equipment, and include periodic wireless surveys in security testing, as recommended in NIST SP 800-153.
Confirm the fix with a further wireless survey, and by checking that the port no longer gives network access to an unknown device.
References
Add This Finding to Your Library
In Pental this write-up is in Settings, Library. Add to my library copies it into your own, rated in your firm's CVSS version, ready to put in your own words.
Free trialYour trial starts when your portal goes live, not when you sign up, so the time you spend setting up does not count. · No card required
Only need the reporting? Our reporting tool is free and open source, with the same library.